Get integrated CAD, CAM, CAE & PCB on a single development platform. Please create a tutorial fully defining the intended effects that modifying the tilt angles should have for the following multi-axis milling contour options: Trim/Fail/Turn Impossibilities Forward Tilt Sideways Tilt Minimum Tilt Maximum Tilt Maximum Fan Distance Maximum Tool Axis Sweep We will see if this gains traction by the votes in this community. Fusion 360 unifies design, engineering, electronics, and manufacturing into a single software platform. A recent example, cutting in P20 Mold steel I used a 10mm Ball Nose (0.375') with a 20mm (0.75') depth of cut and 1mm (0.04') Radial step over running at 12700rpm and feed at 5080mm/Min (16.66 Ft/Min) the job.
Lateral cutting speeds should not exceed 60 inches per minute. Adaptive Clearing is all about 'Constant cutter engagement' your limit now becomes the cutter flute length and the speed of your machine. Plunge (drill) speeds should not exceed 6 inches per minute.
I've searched youtube and forums and have found a couple of tutorials, but no full definitions outside of the 5-word definitions in HSM when you hover over the options. website: Note: Transit (non-cutting) speeds should not exceed 70 inches per minute. I'm confused why only 5 degrees was the amount changed and I want to eliminate that confusion. The program simulates in HSMWorks okay and the block form is within the machines limits. We are committed to producing the highest quality machined parts with the highest level of customer service. I am setting up a 4th (A) Axis on a machine with a Heidenhain iTNC 530 control and the machine wants to go outside of its limits in the X and Y when running any multi axis tool paths. is a full-service machine shop located in Smyrna, TN, just 15 miles Southeast of Nashville.
I say this as if I change a forward tilt angle to 30 degrees then my toolpath will change 5 degrees, when I expect a 20 degree change to follow and machine my contour perfectly. Turner Machine is looking for multiple Manual Machinist as well as CNC Machinist with Mastercam / HSMWorks experience. I would like to know the effects that modifying multi-axis tilt angles will have on my toolpaths so I can program efficiently and with confidence in Autodesk HSMWorks. What my perceptions of the definitions are do not match what happens to the toolpaths.